EasyManua.ls Logo

Pontiac tempest 1968 - Page 376

Pontiac tempest 1968
740 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-1
CLUTCH,
MANUAL TRANSMISSIONS
CONTENTS
OF
THIS
SECTION
SUBJECT PAGE
General
Description
......
7-1
Periodic
Service
Lubrication
7-1
Clutch
Pedal Adjustment 7-1
Service
and Repairs
Clutch
Control Linkage-
Remove and Replace 7-2
Clutch—Remove
and Replace 7-2
SUBJECT PAGE
Flywheel
or
Clutch
Pilot Bearing-
Remove and Replace . . 7-5
Procedure
for Removing and Installing
Starter
Ring
Gear
on Flywheel 7-6
Specifications
Clutch
7-6
Torque
7-6
GENE1AI
DESCRIPTION
Several
clutches are being used, depending on the
engine
option. The clutches differ in diaphragm
spring
design, damper spring calibration and driven
disc diameter.
Clutch
usages
are shown in Fig. 1.
PERIODIC
SERVICE
LUBRICATION
Every
6,000
miles, lubricate all pivot points with
engine
oil. Use light grease at push rod to clutch
fork
pin joint and chassis grease at high pressure
lubrication
fitting. The
ball
type
release bearing
is lubricated and sealed for life and requires no
lubrication.
CLUTCH PEDAL ADJUSTMENT (Figs.
7-3, 7-4 and 7-5)
Wear
on the clutch parts
necessitates
occasional
lash
adjustment. No other adjustment is made.
Lash
adjustment should be made as follows:
1. Remove the return spring.
2. With clutch pedal against
stop:
Loosen jam nut
sufficiently to allow the adjusting rod to be turned
out of swivel and
rearward
against the clutch fork
until
the release bearing contacts pressure plate
fingers lightly.
3.
Rotate adjusting rod into swivel 3 1/2 turns and
tighten jam nut 10 lb. ft. torque.
4. Reinstall spring. Approximately 1" of lash
should be at the pedal.
Diaphragm
Spring
Design
Driven
Disc
Diameter
(inches)
Color
and number of
Damper
Springs
PONTIAC
400 cu. in. 4-Bbl. &
428 cu. in. All
Bent-finger 11.0
5
no paint
400 cu. in. 2-Bbl.
Flat
-finger*
10.4 6 red
TEMPEST
AND
FIREBIRD
6-cyL
1-Bbl.
Flat
-
finger
10.0
6 orange
6-cyL
4-Bbl.
Bent-finger
10.4
5
dark
gray
350 cu. in. 4-Bbl.
Bent-finger 10.4 6 red
400 cu. in. 4-Bbl.
Bent-finger
10.4
5
black
350 cu. in. 2-Bbl.
Flat-finger*
10.4
6 red
*Two
Clutch
covers used, one
made by Borge
&
Beck and the other by Chevrolet.
Fig.
7-1
Clutch Usage

Table of Contents

Related product manuals