Pontiac tempest 1968 - Detent Spring Assembly

7E-14 1968 PONTIAC SERVICE MANUAL
Fig. 7E-16 Remove Strainer Bolt
6. Remove the strainer retainer bolt (Fig. 7E-16).
7. Remove intake pipe to case O-ring seal from
intake pipe or case and discard.
REMOVAL OF CONTROL VALVE ASSEMBLY,
SOLENOID CONNECTOR, GOVERNOR PIPES AND
DETENT SPRING ASSEMBLY
1. Remove control valve body attaching screws
and detent roller spring assembly (Fig. 7E-18).
NOTE: Do not remove solenoid attaching screws.
2. Disconnect solenoid lead from connector
terminal.
3. Remove control valve body assembly and gover-
nor pipes (Fig. 7E-19).
CAUTION: Do not drop manual valve.
1
DETENT ROLLER AND
SPRING ASSEMBLY
/
/
Fig. 7E-18 Removing Detent Roller and Spring Assembly
4. Remove governor pipes from control valve
assembly.
5. Remove control valve assembly to spacer
gasket.
REMOVAL OF REAR SERVO, VALVE BODY SPACER,
GASKET AND FRONT SERVO
1. Remove rear servo cover attaching screws,
servo cover and gasket. Discard gasket (Fig. 73-20).
2. Remove rear servo from case (Fig. 7E-21).
3. Remove rear servo accumulator spring.
4. Make band apply pin selection check to deter-
mine possible cause of malfunction (Fig. 7E-22).
Fig. 7E-19 Removing Control Valve Assembly
Fig. 7E-17 Removing Strainer and Intake Pipe Assembly and Governor Pipes from Case