Contents
Quick Connector
with Washer
Middle Pipe Assembly
Lower Hose Bracket
Lower Pipe Assembly
Shower Hose
Upper Pipe Assembly
Hose Guide Bracket
Upper Shower
Head Bracket
Shower Head
Set Screw
Support Base
Shower On-O Valve
Set Screw
Base Cap
1
2
3
4
5
6
7
8
9
10
Recommended Tools
Phillips
Screwdriver
Rubber
Mallet
Adjustable
Wrench
2
Assembly Instructions
1
2
3
4
5
6
7
8
9
10
Fill the support base with water or sand. Insert
the base cap.
Insert the lower pipe assembly into the base
and secure with (1) set screw.
Attach shower hose to shower on/o valve
(shower hose threads come with teon tape
pre-applied). The adjustable wrench may be
needed to tighten shower hose into on-o valve.
Insert the middle pipe assembly into the lower
pipe assembly aligning the pre-drilled holes and
secure with (1) set screw. A rubber mallet may
be needed.
Attach the lower hose bracket onto the middle
pipe assembly. Make sure the large hook on the
hose bracket is facing the same direction as the
quick connector.
Insert the upper pipe assembly into the middle
pipe assembly.
Insert the upper shower head bracket onto the
upper pipe assembly.
Connect the hose to the shower head, mount
shower head to the upper shower head bracket of
the upper pipe assembly. NOTE: Snap hose into
bracket and slide shower handle in place. Adjust
angle to your preference.
Attach hose guide bracket half way between
the lower hose bracket and the upper shower
head bracket. Snap in the shower hose to both
hose guide brackets.
Remove quick connector by sliding sleeve in
direction shown to release spring tension.
Attach garden hose to the connector and
re-attach quick connector by sliding over o-ring.
O-Ring
Installed
Sleeve (move sleeve in direction of arrow)
To Next Page
Loading...