OPERATION(Cont.)
Use with power drill
■ NEVER start in the high speed gear, in case the machine will be in an excessive inertia and out of
control to cause injury, you are supposed to set the power drill to the minimum speed before starting
it. (Maximum speed is 500rpm for this drain auger!)
■ ALWAYS hold the drain auger tightly before starting the power drill, avoiding to cause the drain auger
to run out of control due to sudden start.
■ KEEP your hands or body away from the drum when it is rotating during operating.
■ DO NOT let the flexible cable be aimed at your body, in case the flexible cable may pop out and
cause injury.
■ DO NOT force the delivery of the flexible cable, otherwise the flexible cable will twist knotted or be
broken and cause serious injury.
1. Fold the rotary handle to fit the drum.
2. Clamp the ¼” hex drive bar with the drill chuck, then insert into the hex part on the rear part of the
drum.
3. While working, please hold the switch on the front handle of drain auger firmly, gently start the
power drill and then keep it slow to accelerate the speed of the rotation (the maximum speed is
500rpm), by controlling the forward and reverse rotation direction of the power drill, you can keep the
automatic cable in the state of advance or retract easily.
To Next Page
Loading...
