Driving and Driving Safety 223
Warning message
Various messages are indicated on the multi-pur-
pose display of the instrument panel if there is a
system fault or if the compressor switches off due
to overload.
f For further information on warning messages
on the multi-purpose display:
Please observe the chapter “OVERVIEW OF
WARNING MESSAGES” on Page 172.
f Adapt your driving style to the changed condi-
tions.
f Consult an authorized Porsche dealer in order
to remedy a system fault.
f If the overload-protection function causes the
compressor to switch off, wait for a time until
it has cooled down. The system will function
again as soon as it has cooled sufficiently.
The warning message appears when the control
system is switched off and when the collapsible
spare wheel is being filled. This does not indicate
a fault.
The warning message will go out once these pro-
cedures have been completed.
Raising vehicle with the jack
Whenever it is necessary to jack up the vehicle:
f Manually set normal level and then switch off
level control.
Switching off level control
1. Switch ignition on.
2. Push rocker switch forward for 5 to
10 seconds.
A message is shown on the multi-purpose
display of the instrument panel.
The vehicle can now be raised.
Switching level control back on
1. Switch ignition on.
2. Push rocker switch forward for 5 to
10 seconds or
3. Drive forward with the vehicle.
Level control switches on automatically.
Transporting the vehicles on car trains,
ferries and car transporters
f Tie the vehicle down only at its wheels.
To Next Page
Loading...
Need help?
General
