Porsche Cayenne 2020 User Manual

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Jack and Lifting Platform
150
3. Place one wedge each directly in front of and
behind the diagonally opposite wheel.
Raising vehicle with the jack
Information
The jack is only supplied on vehicles with a spare
wheel.
The jack is stored with the tool box under the cargo
area floor in the luggage compartment.
> Please see chapter "Luggage Compartment" on
page 164.
bb On vehicles with leveling system: car jack mode
is switched on.
> Please see chapter "Vehicle Settings" on
page 285.
bb Vehicle is secured to prevent it from rolling away.
bb The jacking area for the jack on the vehicle is
clean.
Fig. 85: Fitting the jack
1. Attach the jack at the jacking points provided.
The jack must be resting on a solid surface.
If necessary, use a suitable large, non-slip
support.
2. Hold the jack and raise it by turning with the
hexagon socket wrench C from the vehicle tool
box until the head piece of the jack A is posi-
tioned under the jacking point on the vehicle.
3. Position the jack so that the head piece A en-
gages in the jacking point on the vehicle and the
jack base B lies flat on the ground. The jack base
B must be located vertically under the jacking
point on the vehicle.
4. To raise the vehicle, fit the appropriate side of
the ratchet D (from tool box) onto the hexagon
socket wrench C. Move the ratchet D back and
forth clockwise until only the wheel to be
changed is lifted completely off the ground.
Lowering:
e To lower the jack, fit the opposite side of the
ratchet D onto the hexagon socket wrench C.
After lowering the vehicle, remove the jack.

Porsche Cayenne 2020 Specifications

General

Brand	Porsche
Model	Cayenne 2020
Category	Automobile
Language	English