To Next PageTo Next Page
Need help?Do you have a question about the Porter-Cable 8624 and is the answer not in the manual?
General| Brand | Porter-Cable |
|---|---|
| Model | 8624 |
| Category | Drill |
| Language | English |
Guidelines for maintaining a clean and safe workspace to prevent accidents.
Precautions related to cord use, battery charging, and tool power sources.
Advice on staying alert, dressing properly, and avoiding distractions during operation.
Disconnect power or lock switch before adjustments or storage.
Tool service must be performed by qualified repair professionals.
Tool is always operational; set trigger to locked OFF when changing bits.
Use only specified charger for battery pack to avoid fire risk.
Do not operate with damaged cords or plugs; have them replaced immediately.
Do not operate a damaged charger; take to a qualified serviceman.
Do not charge battery when temperature is below 32°F or above 104°F.
Do not charge other tool batteries with this charger.
Avoid shorting battery terminals to prevent extreme temperatures, injury, or fire.
Dispose of expended battery packs properly; recycle Ni-Cd batteries.
Ensure reversing button is in locked OFF position before installing/removing bits.
Fully charge the battery pack before first use for optimal performance.
Recharge when tool performance drops; avoid over-discharging the pack.
Do not obstruct vent slots; avoid charging outside 32°F to 104°F.
Steps for connecting charger, battery, and understanding indicator lights.
System checks battery pack temperature and voltage for proper charging.
Interpreting charger lights for battery status and potential issues.
Press release button and pull pack out of tool.
Align rails with slots and push pack onto tool until it locks.
Be aware of live wires; hold tool as shown to prevent shock.
Set torque collar and speed selector; ensure bit is secure.
Secure workpiece in a vise or clamp to prevent spinning and injury.
Release trigger if stalled; do not pump trigger. Reverse rotation may free bit.
Drill pilot and shank clearance holes using suggested sizes from the chart.
Set torque collar for desired torque and speed selector to LOW.
Clean plastic parts with a damp cloth; do not use solvents.
Ensure battery pack is charged and properly installed if the tool fails to start.
Professional lubrication and service only by authorized centers.
Servicing and part replacement should only be done by authorized service centers.
Repairs by authorized agencies are guaranteed; others are not.
