ASSEMBLY
1. Place handle assembly onto frame and connect handle to frame.
2. Connect wand to gun. Tighten securely.
3. Attach high pressure hose to gun. Tighten securely.
5. Assemble grommet kit and quick-connect nozzles as described in
instructions supplied.
6. Add engine oil (supplied) to engine. Refer to engine manual supplied by
engine manufacturer for correct procedure.
NOTE: There will be a slight amount of oil in the engine from factory testing.
NOTE: The high pressure pump was filled with oil at the factory. There is no need
to add oil at this time, see the Maintenance section of this manual for
Maintenance information.
7÷ ENG D25803
To Next Page
Loading...
