3
GENERAL OPERATING INFORMATION
Electrical Supply
Connect control panel to 120 volt AC, 60HZ, 20AMP circuit, with a maximum length to power source of 50 feet. If additional cord
beyond 50 feet is required, a minimum power cable of #10awg is required to prevent power loss and possible damage to controls and
motor assembly.
Backstop Operation
Before attempting assembly of this unit check operation by doing the following:
1. To raise backstop to playing position rotate key switch to the up position. CAUTION
- If backstop is already up on its casters the
unit will lower itself to the floor before boom will start to extend. Hold key until fully extended. WARNING - Release key
switch when unit is fully extended to avoid undue strain on frame and hydraulic system.
2. To lower mast make sure safety T-handle (see Illustration D) is disengaged and secured to backside of mast with lock pin. To
lower mast, rotate key switch to the down position and hold until fully lowered. Unit will start to raise up on casters at this point
for transport. WARNING - Make sure any floor anchoring system is disengaged before unit is raised onto its casters.
Glass Backboard Handling
During assembly of this backstop, it is of extreme importance that the glass backboard is not dropped, attachment bolts are not
improperly torqued (bolts tightened before plumbing all attachment points) or allowing the glass section to contact or strike metal
parts as the backboard warranty does not cover breakage during installation.
CAUTIONS
DO NOT
stand or sit in front of the unit when being raised or lowered.
DO NOT
attempt to lower unit with safety T-handle lock engaged.
DO NOT
have hand or feet under unit when being raised or lowered.
DO NOT
continue to pump unit after cycle (up or down) has been completed.
DO NOT
operate key switch intermittently.
DO NOT
move or roll the backstop with the mast in the up or extended position.
REMOVE
top base pads and rear upright support pads before folding unit to the down position.
DISENGAGE
floor anchor system before lowering unit to the transport position.
DO NOT
allow untrained or unauthorized individuals to operate this backstop.
To Next Page
Loading...