Potec PACP-6100 - 9.2 Fuse Replacement

22 PACP-6100 Operator’s Manual -----------------------------------------------------------------
[Fig. 8 Lamp assembly]
Install the lamp securely as showen in the Fig.8
Make sure that you install it in the correct direction
Turn off power and disconnect the power code. Allow the projector to cool down for
about 5 minutes before replacing the lamp because the heated lamp may burn your
fingers.
9.2 Fuse Replacement
1. Turn off power, and disconnect the power cord.
2. Pull out the plastic cover at the lower part of power socket, to replace the fuse.
Do not touch the projector with wet hands. (Risk of electric shock)
!
WARNING
!
WARNING