Need help?Do you have a question about the Power Acoustik Fanatik PF2.600 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power Output (4 Ohm) | 150W x 2 |
| RMS Power Output (2 Ohm) | 300W x 2 |
| Bridged RMS Power (4 Ohm) | 600W x 1 |
| Peak Power | 1200W |
| Minimum Impedance Unbridged | 2 Ohm |
| Minimum Impedance Bridged | 4 Ohm |
| Frequency Response | 10Hz - 30kHz |
| Signal-to-Noise Ratio | >90dB |
| Input Voltage | 14.4V |
| Input Sensitivity | 200mV-6V |
| Operating Voltage | 10V-16V |
| Bass Boost | 0-18dB |
| Fuse Rating | 2 x 30A |
Details on selecting a flat surface for mounting and drilling holes.
Check power, speaker, and input wires are connected correctly and firmly.
Check speaker wires for short circuits, overload, or high temperature.
Check input cables and source unit if one channel is silent.
Ensure proper ground connection and adjust input level control.
To Next Page
