20
Switch the chain grinder off immediately if the
grinding disc vibrates. Check that the chain
grinder is correctly assembled and that the
grinding disc is not damaged.
NEVER try to stop the grinding disc with your
hands!
Do not touch metal filings until they have cooled.
Do not leave the chain grinder until the grinding
disc has come to a complete standstill. Please note
that it takes a little while for the grinding disc to
come to a complete standstill after you have
switched the chain grinder off.
Assembly
Check that all the parts are present after
unpacking. Contact the dealer if any parts are
missing or damaged.
Attach the base (17) to the workbench using
suitable bolts in the mounting holes (8). The lock
knob (9) must jut out over the edge of the table
and be easily accessible. Check that the chain
grinder is securely attached and level.
Insert plug in mains socket.
ENGLISH
INSTRUCTION MANUAL
Grinding
Preparations
Clean the chain to be ground by rinsing it in non-
flammable solvent. Do not use benzine or similar!
Allow the chain to dry fully.
Lift the chain stop (13), and place the chain in the
chain rail (16).
Lower the chain stop so that it touches the link
(the tooth) you want to start grinding.
To Next Page
