Need help?Do you have a question about the Power Craft PSD-480K and is the answer not in the manual?
General| Voltage | 4.8V |
|---|---|
| Battery Type | Ni-Cd |
| Charging Time | 3-5 hours |
| No-load Speed | 180 RPM |
| Torque | 3 Nm |
| Weight | 0.5 kg |
| Type | Cordless |
Keep ventilation slots clean to prevent overheating; clean housing with soft cloth.
The machine requires no additional lubrication.
Contact Helpdesk Omega Safes for faults; exploded view shows orderable parts.
Recycle packaging materials; dispose of unwanted machines and battery cells environmentally.
Guarantee conditions are on the separately enclosed guarantee card.
Adjust torque setting ring to control screw fastening force; use lowest setting first.
Push top half of direction switch to fasten, lower half to loosen screws.
Press lock to the left to block direction switch after use, preventing unwanted operation.
Unlock battery, connect charger, plug into socket; charging takes 5-24 hours.
Ensure mains voltage matches adapter input; adapter is double insulated.
Covers work area, environment, body contact, children, storage, tool usage, dress, and eye protection.
Instructions regarding accumulator block, battery charger, and specific risks like short-circuiting.
Turn switch to locked position; insert bit into hexagonal driving shaft.
Ensure switch is locked; push battery into tool until it snaps; use release buttons to remove.
Battery life is limited; recharge every six months if unused; capacity reduced in extreme temperatures.
To Next Page
