Powerfix Profi Z16531 User Manual

6 GB/IE
Q
Operation
Q
Filling with staples / nails
CAUTION! Use only the staples and nails
described in these operating instructions (see
“Staples / nails”). Failure to observe this advice
may result in damage to the device.
Follow these steps:
1. Press in the staple pusher
2
slightly and then
pull it downwards. Then pull the staple pusher
2
completely out of the magazine
4
(see Fig. A).
2. Push the staples or the T-nails into the
magazine
4
.
CAUTION! Ensure that the staples or T-nails
are correctly inserted (see Figs. B, C, D).
3. Push the staple pusher
2
back into the
magazine
4
. Press in the staple pusher
2
slightly and then pull it slightly upwards to fix it
in place.
Q
Setting the impact force
CAUTION! Never screw the adjusing screw
7
completely out of the stapler gun. This could
result in damage to the device.
j Screw out the adjusing screw
7
to reduce
the impact force.
j Screw in the adjusing screw
7
to increase
the impact force.
Q
Stapling
CAUTION! Never support yourself by placing
your hands near or in front of the stapler gun
or the workpiece surface. A slip can result in
injury.
Follow these steps:
1. Press the staple eject opening
6
on the spot
where you wish to staple.
2. Adjust the impact force to suit the materials,
staples or nails.
3. Press the operating lever
1
down firmly.
Note: Only trigger the
device whilst firmly
positioned in the area
you wish to work on.
Examples of use:
The stapler gun is suitable for the following purposes:
- Attaching coverings to the seating surface of
chairs.
- Attaching a skirting at the joint between wall
and floor coverings.
- Stretching and stapling canvasses to frames.
- Attaching protective films to insulation materials
when installing thermal insulation.
- Attaching decorative materials.
Q
Removing staples
To avoid the risk of injury!
j Ensure that the operating handle
1
will not be
pressed
j Push the hook
3
under the staple or nail head
(see Fig. F).
j Pull the rear part of the stapler gun upwards to
draw out the staple or nail from the workpiece.
Q
Removing jammed staples
from the stapler gun
Staples or nails may become jammed in the stapler
gun during operation. Remove jammed staples as
follows:
1. Press in the staple pusher
2
slightly and then
pull it downwards. Then pull the staple pusher
2
completely out of the magazine
4
.
2. Turn the stapler gun over so that the magazine
4
is pointing upwards.
3. Press the magazine
4
at the side wings
5
backwards and pull the magazine
4
upwards
(see Fig. E).
4. Now remove the jammed staples from the
magazine
4
.
5. Press the magazine
4
at the side wings
5
backwards and press it downwards until it
engages to fix the magazine
4
back in place.

Powerfix Profi Z16531 Specifications

General

Brand	Powerfix Profi
Model	Z16531
Category	Power Tool
Language	English