12 GB/IE
stapler on the material to be attached.
If the staple does not penetrate
enough into the wood, increase the
striking force slowly until the staple
finishes flush with the material to be
attached.
j Do not strike too hard. The crown of
the staple must not cut through the
material to be attached.
j Remove any staples jammed in the
magazine with a pair of pointed
pliers.
j Empty the magazine after you have
finished work (see Section “Filling or
emptying the magazine”).
j Have the product repaired at an
authorized workshop only.
To Next Page
Loading...
Need help?
General
