Powerplus POWXG90420 - Page 9

POWXG90420 EN
Copyright © 2018 VARO P a g e | 9 www.varo.com
Should the machine by mistake be frozen, it will be necessary to check it for damage.
WARNING: Never start up a frozen machine. Frost damages are not covered
by the guarantee!
11 TROUBLE SHOOTING
SYMPTOM
CAUSE
RECOMMENDED ACTION
Machine refuses
to start
Machine not plugged
in
Plug in machine.
Defective socket
Try another socket.
Defective extension
cable
Try without the extension cable.
Fluctuating
pressure
Pump is sucking air
Check that hoses and connections are
airtight.
Valves dirty, worn out
or stuck
Contact your nearest service centre.
Water supply not
sufficient
Increase water pressure, check for
blockage of garden hose and/or change to
bigger hose.
Pump seals worn
Contact your nearest service centre.
Machine stops
Incorrect mains
voltage
Check that the mains voltage corresponds
to specification on the name plate.
Thermal sensor
activated
Leave the machine for 5 minutes to cool
down.
Nozzle partially
blocked
Clean the nozzle with a needle and by
spraying water backwards through the
nozzle.
Amperage increase
Try without the extension cable.
Machine
pulsating
Air in inlet hose/pump
Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply of
mains water
Increase water pressure, check for
blockage of garden hose and/or change to
bigger hose.
Nozzle partially
blocked
Clean the nozzle with a needle and by
spraying water backwards through the
nozzle.
Water filter blocked
Clean the filter.
Hose kinked
Straighten out hose.
Machine often
starts and stops
by itself
Pump and/or trigger
gun is leaking
Contact your nearest service centre.
No water supply
Connect inlet water.
Machine starts
but no water
comes out
Water filter blocked
Clean the filter.
Nozzle blocked
Clean the nozzle with a needle and by
spraying water backwards through the
nozzle.