Powers P3X - Troubleshooting Malfunctions; Parts List and Diagram

12 13
Model P3X Model P3X
MALFUNCTION AND SOLUTIONS
ALWAYS CHECK INSTRUCTION MANUAL
FOR PROPER ASSEMBLY OF PARTS
PROBLEM CAUSES REMEDIES
Malfunctioning of the
charge feed or percussion
device
- Insufficient force on the tool
when resting it on the support
- The charger disc has not turned
- Munition carrier sleeve not
sliding properly
- Malfunctioning of the charge disc
- No more pins in the magazine
- Barrel dirty
- Tool too hot
- Hold the tool resting on the
support
- Check the condition of the
lever assembly
- Disassemble and clean
- Check it
- Add pins
- Disassemble and clean
- Allow to cool
Barrel jammed at the back - Moving assembly (barrel dirty)
- Tool too hot
- Disassemble and clean
- Allow to cool
Lack of power or fluctuation
in power
- Deterioration of the piston
- Piston very eroded
- Deterioration of the rubber
return spring
- Deterioration of the insulation ring
- Change it
- Change it
- Change it
- Change it
Too much force needed to
rest the tool on the support
- Barrel dirty
- Presence of foreign matter
- Clean, oil and reassemble
- Clean, oil and reassemble
Impossible to close the
magazine’s cover
- More than 10 pins in the magazine
- Pin guide not sliding properly
- Remove the pins
- Contact POWERS tool service
department
Piston jammed - Accumulated strip residue - Clean
Poor pin feed - Residue in magazine
- Pin guide not sliding properly
- Clean
- Contact POWERS tool service
department
P3X REAR (HANDLE)
Only your POWERS agent or his
representative is authorised to
disassemble this assembly
15 14 13
25
19 18 17
12
11
10
16
3 2 1
6
4
5
7
27
24
26
21
20
22
8
9
23
28
Part Part No. Description
A1 57400 STABILISER
A2 57402 PIN GUIDE COVER
A3 57404 PIN GUIDE
A4 57406 MAGAZINE STABILISER ASSEMBLY
A5 57408 MAGAZINE BOX ASSEMBLY
A6 57410 PIN SLIDER ASSEMBLY
A7 57412 MAGAZINE LOCK ASSEMBLY
A8 57414 MAGAZINE COVER ASSEMBLY
A9 57416 FOLLOWER ASSEMBLY
A10 57418 INDEXING ASSEMBLY
A11 57420 MAGAZINE GUIDE
A12 57422 MAGAZINE RETURN ASSEMBLY
A13 57424 PISTON RETURN SPRING
A14 57426 INSULATION RING
Part Part No. Description
A15 57428 PISTON
A16 57430 BARREL SPRING ASSEMBLY
A17 57432 RECEIVER NUT
A18 57434 STOP RING ASSEMBLY
A19 57436 BARREL ASSEMBLY
A20 57438 RECEIVER ASSEMBLY
A21 57440 FIRING ASSEMBLY
A22 57442 LEVER ASSEMBLY
A23 57444 TRIGGER ASSEMBLY
A24 57446 COVER ASSEMBLY
A25 57448 COVER LOCK ASSEMBLY
A26 57450 SIDE HANDLE ASSEMBLY
A27 57452 REAR HANDLE ASSEMBLY
A28 57454 ENERGY SET ASSEMBLY
POWERS P3X POWDER ACTUATED FASTENING TOOL
PARTS LIST
ALWAYS UNLOAD THE TOOL
• On completion of work
• Before changing any parts
(piston, return spring, etc.)
• Before doing any cleaning or
maintenance
P3X Inst Manual Update 14-8-13.indd 12-13 8/14/2013 9:44:56 AM