Southern Technologies, LLC
Waukegan, IL 60087
Put these instructions and the original sales invoice in a safe,
dry place for future reference.
Visit us on the web at www.powertecproducts.com
2. If the tool is equipped with a T-slotted miter slot, use the
included 2.5 mm hex wrench to ensure the screw holding
the miter bar plate is tight. If the tool is not equipped with a
T-slotted miter slot, remove the plate. Save these parts.
Miter Gauge Bar
Screw
Miter Bar Plate
Figure 5
3. Place the miter bar into the miter slot and check for side
movement. If the miter gauge guide bar moves freely through
the miter slot and has no side to side play, no adjustment
is needed.
If adjustment is needed:
The four expansion disc located on the top of the miter bar
can be adjusted to remove any side movement. Use the
2.5 mm hex wrench to tighten the screws until all side motion
is removed. Turn the screws clockwise to tighten the fit and
counterclockwise to loosen the fit. Ensure the bar slides freely
in the miter slot.
Expansion Disc Screw
Figure 6
Expansion Disc
Screw
INSTALL THE FENCE AND FENCE FLIP STOP
Refer to Figure 7
1. Position the fence so the engraved scale reads right to left.
2. Loosen the two knobs on the back of the miter face and slide
the T-bolts into the appropriate slot of multi track fence.
3. Slide fence to the desired position and tighten the two knobs.
4. Install the fence flip stop per the supplied flip stop instruction.
Multi Track Fence
Figure 7
Knobs
T-Bolt
T-Bolt
SETTING THE GAUGE TO 90°
Refer to Figure 8
1. Loosen the four screws located on the miter gauge face with
the 3 mm hex wrench.
2. Use a square to set the miter bar and miter gauge
face perpendicular.
3. While holding the square, tighten the four screws.
3 2 1
21 3 4 5 6 7
Square
Figure 8
Miter
Gauge
Face
Miter Bar
Screws
TO USE
Refer to Figure 9
• The precision miter gauge system is ready to use.
• Loosen the handle and small lock knob, move the indexing
tooth to the desired angle.
• Tighten the small lock knob first and then the handle. Ensure
both are tight.
NOTE: The miter gauge is designed to work with the included
71488 multi T-track fence, it can also be used as a conventional
miter gauge.
NOTE: A wooden fence can be added to the multi T-track fence
or attached directly to the miter gauge face (without the multi
T-track fence).
Miter Head
Handle
Figure 9
Lock Knob
Indexing Lever
Knob
T-Bolt
T-Bolt
Knob
To Use as a Conventional Miter Gauge
• Remove the 71488 multi T-track fence.
• Remove the knobs and T-bolts from the miter gauge face and
place in a safe place for future use. Then use as a conventional
miter gauge.
To Previous Page
Loading...