Powerwerx SS-30DV - Safety Warnings and Precautions; Indoor Installation Caution; Safe Operation Warnings; Servicing Warning

Cauon: Install Indoors
Install the power supply indoors. It is not
designed for operaon out-of-doors or in wet
environments.
Warning: Safe Operaon
To reduce the risk of re or electric shock,
please adhere to these warnings:
• Moisture: Do not expose this appliance to
water or moisture.
• Cleaning: Unplug the power supply from
the mains power outlet before cleaning.
Switching o the power supply will not
reduce this risk.
• Venlaon: Place the power supply in an
area that will allow air to ow freely around
the unit. This will prevent the power supply
and mobile radio from overheang. Do
not block or obstruct any of the venlaon
openings on the unit.
Warning: Servicing
This power supply should be serviced by a
qualied service technician. Incorrect assembly
may result in electric shock or re. This power
supply contains no user serviceable parts inside.
Some of the components inside the power supply
can operate at voltage levels that may be lethal.
SS-30DV & SPS-30DM ▪ Rev 4/2015
SS-30DV & SPS-30DM User Manual
23695 Via Del Rio, Yorba Linda, CA 92887 ▪ 714-674-0073 Phone ▪ 714-674-4949 Fax
Warning: Electrical Connecons
To reduce the risk of re or electric shock, please
adhere to these warnings:
The power supply should be properly connected
and grounded. Use the provided AC power cable
to connect the power supply to a mains power
outlet that is properly installed and grounded, in
accordance with all local codes and ordinances.
If the power supply cord is damaged, it must
be replaced with the same type to comply with
safety requirements.
Warranty
The Powerwerx support policy is simple: we want you to be
happy! If you have a problem, please feel free to contact us
and we will do our best to get you up and running as soon as
possible.
Powerwerx power supplies have a three-year limited warranty.
We will repair or replace (at our discreon) your power supply
if you encounter any problems within three years from the
date of purchase. We reserve the right to charge a reasonable
fee for repairing units with user-inicted damage. It is your
responsibility to ship the defecve unit back to Powerwerx.
We will pay for the return shipping back to you. We reserve
the right to upgrade your equipment to an equivalent or beer
model.
Troubleshoong
Condion Soluon Possible Cause
Low DC Power Supply
output
Power supply AC input voltage switch is not in
the correct posion
On rear panel, change the AC selector switch from
230V to 115V.
No DC output current Power Supply not receiving AC input voltage
or is not receiving correct input voltage
• Power Supply liming output due to
overload or ambient over temperature
condion
• Defecve Power Supply
Using a voltmeter, conrm AC input voltage. Check
input connecons. Conrm correct AC power cable
is installed.
• Reduce DC load to 25A or less and/or determine
cause of over temperature condion.
• Return to place of purchase or contact Powerw-
erx for return authorizaon.
Power supply repeatedly
trips input circuit breaker
with no load connected.
Incorrect input voltage is being applied while
should be 100-120 VAC or 200-240 VAC.
Using a voltmeter, conrm AC input voltage. Confrim
input voltage switch is in the correct posion. Con-
rm correct AC power cable is installed.