22
Chapter 5 Function parameter
5-1.Menu grouping
Note:
“★”: In running status, can not modify the parameter setting
“●”: The actual testing data, can not be modified
“☆”: In stop and run statuses, both can be changed;
“▲”: “Factory parameter”, no change about it.
“_” means the factory parameter is related to power or model. Please check the details in the
involved parameter introduction.
Change limit refers to whether the parameters are adjustable.
In PI160 frequency inverter,some of parameters are reserved by manufacturer,they are not
listed in the parameter function, it might lead to disconnection between the parameters,about
this,please don’t try to revise to avoid the fault.
y0.01 is used for parameters protection password. Parament menu can be enter into only after
inputting the right password in the function parament mode or user change parameter mode. When
the y0.01 setted to 0, the password is canceled.
Parameter menu is not protected by password under user customized parameters mode.
F group is the basic function parameters,E group is to enhance function parameters, b group is
a function of motor parameters, d group is the monitoring function parameters.
PI160 series inverter and some parameters for the manufacturer reserves ", the serial number
of which is not listed in the function parameter list, lead to partial parameters of serial connection,
for manual does not introduce parameters, please users don't try to change, avoid causing the error.
Monitoring function group
Monitoring frequency, current, etc
Frequency setting, control mode, acceleration and
deceleration time
Analog and digital input functions
Analog and digital output functions
Start and stop control group
Start and stop control parameters
Vector control parameters
Vector control parameters
To set key and display function parameters
To set Jog, jump frequency and other auxiliary
function parameters
To set fault and protection parameters
Communication parameter group
To set MODBUS communication function
Torque control parameters
To set parameters under torque control mode
Control optimization parameters
To set parameters of optimizing the control
To Next Page
Loading...
