Powtran PI500-S 022G3 - B0 Motor Parameter Group

Chapter 5 Function parameter
47
Chapter 5
selection of DI
High level effectively
1
Tens digit
AI2(same as units digit)
Hundreds digit
AI3(same as units digit)
This group function code is used when using AI as DI, when AI used as DI, and input voltage
of AI is greater than 7V, AI terminal status will be high level, when input voltage of AI is lower
than 3V, AI terminal status will be low level. For between 3V~ 7V hysteresis E3.10 is to determine
that when the AI is used as DI, AI is made valid by means of the high level state, or the low level
of valid states. As for AI as DI feature set, same as the ordinary DI Settings, please refer to the F1
group setting instructions related DI. Below figure is AI input voltage taken as an example,
explains the relationship between input voltage of AI and the corresponding state of DI.
E3.11
VDO1 output
function
With the physical internal sub DIx
0
0
☆
See F2 group physical DO output option
1 to 40
E3.12
VDO2 output
function
With the physical internal sub DIx
0
0
☆
See F2 group physical DO output option
1 to 40
E3.13
VDO3 output
function
With the physical internal sub DIx
0
0
☆
See F2 group physical DO output option
1 to 40
E3.14
VDO4 output
function
With the physical internal sub DIx
0
0
☆
See F2 group physical DO output option
1 to 40
E3.15
VDO5 output
function
With the physical internal sub DIx
0
0
☆
See F2 group physical DO output option
1 to 40
E3.16
VDO output
effective status
Units digit
VDO1
00000
☆
Positive logic
0
Negative logic
1
Tens digit
VDO2(0 to 1，same as above)
Hundreds digit
VDO3(0 to 1，same as above)
Thousands digit
VDO4(0 to 1，same as above)
Ten thousands digit
VDO5(0 to 1，same as above)
E3.17
VDO1 output delay time
0.0s to 3600.0s
0.0s
☆
E3.18
VDO2 output delay time
0.0s to 3600.0s
0.0s
☆
E3.19
VDO3 output delay time
0.0s to 3600.0s
0.0s
☆
E3.20
VDO4 output delay time
0.0s to 3600.0s
0.0s
☆
E3.21
VDO5 output delay time
0.0s to 3600.0s
0.0s
☆
5-1-15.b0 motor parameter group
Code
Parameter name
Setting range
Factory
setting
Change
Limit
b0.00
Motor type selection
General asynchronous motor
0
0
★
Asynchronous inverter motor
1
Retain
2
b0.01
Rated power
0.1kW to 1000.0kW
-
★
b0.02
Rated voltage
1V to 2000V
-
★
b0.03
Rated current
0.01A to 655.35A
-
★