Powtran PI500-S Series - Page 33

Chapter 5 Function parameter
29
Chapter 5
K1
K2
Command
0
0
0
1
1
0
1
1
Stop
REV
FWD
DIx Forward (FWD)
DIy Reverse (REV)
COM Digital common
terminals
K1
K2
Stop
1:Two-wire type 2
In the mode, DIx terminal is used as running enabled, while DIy terminal is used to determine
running direction.
The terminal function is set as follows:
Terminals
Set value
Description
DIx
1
Forward run(FWD)
DIy
2
Reverse run(REV)
Of which, DIx and DIy are the multi-function input terminals of DI1 to DI10, the levelis
active.
K1
K2
Command
0
0
0
1
1
0
1
1
Stop
REV
FWD
DIx Forward (FWD)
DIy Reverse (REV)
COM Digital common
terminals
K1
K2
Stop
Two-wire mode 2
2:Three-wire control mode 1
For this mode,DIn is used as enabled terminal,while DIx and DIy terminal are used to control
direction.The terminal function is set as follows:
Terminal
Set value
Description
DIx
1
Forward run(FWD)
DIy
2
Forward run(REV)
DIn
3
Three-wire operation control
To run, firstly close DIn terminal, the motor run signal is generated by the ascendant edge of
DIx, the motor direction signal is generated by DIy status
To stop, you must disconnect DIn terminal signals Of which, DIx, DIy and DIn are the multi-
function input terminals of DI1 to DI10, DIx is for active pulse, DIy and DIn are for active level.
DIx
DIn
DIy
COM
Forward run FWD
Three-wire operation
control
Digital common
terminals
Reverse run REV
SB2
SB1
SB3
Three-wire control model 1
Of which:SB1:Stop button SB2:Forward button SB3:Reverse button
3:Three-wire control mode 2
For this mode,DIn is the enabled terminal,,the runing commands are given by DIy,the
direction is determined by the state of DIy.
The terminal function is set as follows:
Terminal
Set value
Description
DIx
1
Forward run(FWD)
DIy
2
Reverse run(REV)
DIn
3
Three-wire operation control
To run, firstly close DIn terminal, the motor run signal is generated by the ascendant edge of