Powtran PI500 series - Page 35

Chapter 5 Function parameter
31
Chapter 5
Tens digit: terminal command
binding frequency source
selection (0 to 9, same as units
digit)
Hundreds digit: communication
command binding frequency
source selection (0 to 9, same as
units digit)
55.
F0.13
Acceleration time 1
0.00s to 6500s
Depends
on models
☆
56.
F0.14
Deceleration time 1
0.00s to 6500s
Depends
on models
☆
57.
F0.15
Ac/Deceleration time unit
0:1 second；1:0.1 second；
2:0.01 second
1
★
58.
F0.16
Ac/deceleration time reference
frequency
0: F0.19(maximum frequency)
1: Set frequency
2: 100Hz
0
★
59.
F0.17
Carrier frequency adjustment as
per temperature
0:
NO； 1:
YES
0
☆
60.
F0.18
Carrier Frequency
0.5kHz to 16.0kHz
Depends
on
models
☆
61.
F0.19
Maximum output frequency
50.00Hz to 320.00Hz
50.00Hz
★
62.
F0.20
Upper limit frequency source
0: F0.21 setting
1: AI1analog quantity setting
2: AI2 analog quantity setting
3: Panel potentiometer setting
4:
High-speed pulse setting
5:
communications reference
6:AI3 analog quantity setting
0
★
63.
F0.21
Upper limit frequency
F0.23 (lower limit frequency)
to F0.19(maximum frequency)
50.00Hz
☆
64.
F0.22
Upper limit frequency offset
0.00Hz to F0.19 (maximum
frequency)
0.00Hz
☆
65.
F0.23
Lower limit frequency
0.00Hz to F0.21 (upper limit
frequency)
0.00Hz
☆
66.
F0.24
Running direction
0:
same direction
1: opposite direction
0
☆
67.
F0.25
Reserve
68.
F0.26
Reserve
69.
F0.27
GF type
1.G type (constant torque load
type)
2.F type (fans/pumps load type)
-
●