Powtran PI500 series - Torque Control Parameters (FA.00-FA.07)

Chapter 5 Function parameter
45
Chapter 5
298.
F9.07
Baud rate
Units digit:MODBUS
Tens digit:Profibus-DP
Hundreds digit:Reserve
Thousands digit:CAN bus baudrate
6005
☆
5-1-12.FA Group - Torque control parameters
No.
Code
Parameter name
Setting range
Factory
setting
Chan
ge
299.
FA.00
Speed/torque control mode
selection
0: speed control 1: torque
control
0
★
300.
FA.01
Torque setting source selection
under torque control mode
0: keyboard setting (FA.02)
1: Analog AI1 setting
2: Analog AI2 setting
3: Panel potentiometer setting
4: High-speed pulse setting
5: Communications reference
6: MIN (AI1, AI2)
7: MAX (AI1, AI2)
8.
High-speed pulse setting
0
★
301.
FA.02
Torque figures setunder torque
control mode
-200.0% to 200.0%
150%
☆
302.
FA.03
Torque control acceleration time
0.00s to 650.00s
0.00s
☆
303.
FA.04
Torque control deceleration time
0.00s to 650.00s
0.00s
☆
304.
FA.05
Torque control forward
maximum frequency
0.00Hz to F0.19(maximum
frequency)
50.00
Hz
☆
305.
FA.06
Torque control backward
maximum frequency
0.00Hz to F0.19 (maximum
frequency)
50.00
Hz
☆
306.
FA.07
Torque filter time
0.00s to 10.00s
0.00s
☆
5-1-13.FB Group - Control optimization parameters
No.
Code
Parameter name
Setting range
Factory
setting
Chang
e
307.
FB.00
Fast current limiting manner
0: Invalid 1: enable
1
☆
308.
FB.01
Under-voltage point setting
50.0% to 140.0%
100.0%
☆
309.
FB.02
Over-voltage point setting
200.0V to 2500.0V
810V
☆
310.
FB.03
Deadband compensation
mode selection
0: no compensation
1: compensation mode 1
2: compensation mode 2
1
☆
311.
FB.04
Current
detection
compensation
0 to 100
5
☆
312.
FB.05
Vector optimization without PG
mode selection
0:
no optimization
1: optimization mode 1
2: optimization mode 2
1
☆