Powtran PI500 series - Fault Query (y1.00-y1.30)

Chapter 5 Function parameter
55
Chapter 5
5-1-21.y1 Group -Fault query
No.
Code
Parameter name
Setting range
Factory
setting
Chang
e
469.
y1.00
Type of the first
fault
0: No fault
1: Inverter unit protection
2: Acceleration overcurrent
3: Deceleration overcurrent
4: Constant speed overcurrent
5: Acceleration overvoltage
6: Deceleration overvoltage
7: Constant speed overvoltage
8: Control power failure
9: Undervoltage
10: Inverter overload
11: Motor Overload
12: Input phase loss
13: Output phase loss
14: Module overheating
15: External fault
16: Communication abnormal
17: Contactor abnormal
18: Current detection abnormal
19: Motor self-learning abnormal
20: Encoder/PG card abnormal
21: Parameter read and write abnormal
22: Inverter hardware abnormal
23: Motor short to ground
24: Reserved
25: Reserved
26: Running time arrival
27: Custom fault 1
28: Custom fault 2
29; Power-on time arrival
30: Load drop
31: PID feedback loss when running
40: Fast current limiting timeout
41: Switch motor when running
42: Too large speed deviation
43: Motor overspeed
45:Motor over-temperature
51:Initial position error
COF: communication failure
-
●
470.
y1.01
Type of the second
fault
-
●
471.
y1.02
Type of the third(at last)
fault
-
●
472.
y1.03
Frequency of the
third(at last) fault
-
-
●
473.
y1.04
Current of the third(at
last) fault
-
-
●
474.
y1.05
Bus voltage of the
third(at last) fault
-
-
●
475.
y1.06
Input terminal status of
the third(at last) fault
-
-
●