Powtran PI500-W Series - Function Parameters

23
第
十
章
Chapter 5
Chapter 5 Function parameter
5-1.Menu grouping
Note:
“★”: In running status, can not modify the parameter setting
“●”: The actual testing data, can not be modified
“☆”: In stop and run statuses, both can be changed;
“▲”: “Factory parameter”, no change about it.
“_” means the factory parameter is related to power or model. Please check the details in the
involved parameter introduction.
y0.01 is used for parameters protection password. Parameter menu can be enter into only after
inputting the right password in the function parameter mode or user change parameter mode. When
the y0.01 set to 0, the password is canceled.
Parameter menu is not protected by password under user customized parameters mode.
F group is the basic function parameters,E group is to enhance function parameters, b group is
a function of motor parameters,d group is the monitoring function parameters.
Note: Some parameters of PI500-W constant voltage water supply special inverter are
“factory reserved”, the serial number is not listed in the function parameter table, and some
parameter numbers in the table are not connected. For the parameters not mentioned in the manual,
please do not try to make changes to avoid causing errors.
Code
Parameter name
Functional Description
d0
Monitoring function group
Monitoring frequency, current, etc
F0
Basic function group
Frequency setting, control mode, acceleration and
deceleration time
F1
Input terminals group
Analog and digital input functions
F2
Output terminals group
Analog and digital output functions
F3
Start and stop control group
Start and stop control parameters
F4
V/F control parameters
V/F control parameters
F5
Vector control parameters
Vector control parameters
F6
Keyboard and display
To set key and display function parameters
F7
Auxiliary function group
To set Jog, jump frequency and other auxiliary function
parameters
F8
Fault and protection
To set fault and protection parameters
F9
Communication parameter
group
To set MODBUS communication function
FA
Torque control parameters
To set parameters under torque control mode
Fb
Control optimization
parameters
To set parameters of optimizing the control performance
FC
Extend parameters group
specialapplicationparameterssetting
E0
Wobbulate, fixed-length and
counting
To set Wobbulate, fixed-length and counting function
parameters
E1
Multi-stage command,
simple PLC
Multi-speed setting, PLC operation
E2
PID function group
To set Built-in PID parameters
E3
Virtual DI, Virtual DO
Virtual I/O parameter setting