Powtran PI500-W Series - Page 79

Appendix I
75
Appendix I
3000
0001: Forward run
0002: Reverse run
0003: Stop
Parameter lock password verification: (If the return code is 8888H, it indicates that password
verification is passed)
Password adress
Enter password
C000
*****
Digital output terminal control: (write only)
Command address
Command content
2001
BIT0: SPA output control
BIT1: RELAY2 output control
BIT2 RELAY1 output control
BIT3: Manufacturer reserves the undefined
BIT4: SPB switching quantity output control
Analog output DA1 control: (write only)
Command address
Command content
2002
0 to
7FFF
indicates 0％ to 100％
Analog output DA2 control: (write only)
Command address
Command content
2003
0 to 7FFF
indicates
0％ to 100％
SPB high-speed pulse output control: (write only)
Command address
Command content
2004
0 to 7FFF
indicates
0％ to 100％
Inverter fault description:
Inverter fault
address:
Inverter fault information:
8000
0000:No fault
0014:Encoder/PG card abnormal
0001:Inverter unit protection
0015:Parameter read and write abnormal
0002:Acceleration overcurrent
0016:Inverter hardware fault
0003:Deceleration overcurrent
0017:Motor short to ground fault
0004:Constant speed overcurrent
0018:Reserved
0005:Acceleration overvoltage
0019:Reserved
0006:Deceleration overvoltage
001A:Running time arrival
0007:Constant speed overvoltage
001B: Customer self-defined fault 1
0008:Control power failure
001C: Customer self-defined fault 2
0009:Undervoltage fault
001D: Power-on time arrival
000A:Inverter overload
001E:Load drop
000A:Inverter overload
001F:PID feedback loss when running
000A:Inverter overload
0028:Fast current limiting timeout
000B:Motor Overload
0029:Switch motor when running fault
000C:Input phase loss
002A: Too large speed deviation
000D:Output phase loss
002B:Motor overspeed
000E:Module overheating
002D:Motor overtemperature
000F:External fault
005A:Encoder lines setting error
0010:Communication abnormal
005B: Missed encoder
0011:Contactor abnormal
005C:Initial position error
0012:Current detection fault
005E:Speed feedback error
0013:Motor parameter auto
tunning fault
Data on communication failure information description (fault code):
Communication
fault address
Fault function description