Powtran PI8600 Series - Page 51

Section V Parameter Function Table
49
Section V
potentiometer set
Displaying value potentiometer set, which can be revised by potentiometer under monitor
menu.
Value potentiometer set can be regarded as analog of frequency giving , set value = max
frequency*keyboard potentiometer set value.
Potentionmeter set value can be regarded as value of PID giving,value of PID
giving=keybaord potentiometer set value.
A48
Keyboard potentiometer X1
corresponding value Y1
-100.00~100.00
%
0.00
Y
A49
Keyboard potentiometer X2
corresponding value Y2
-100.00~100.00
%
100.00
Y
end point
start point
Start point
corresponding
value
End point
corresponding
value
end point
start point
Start point
corresponding
value
End point
corresponding
value
A50
Keyboad
potentiometer
control
1bit
Saving after power down
0
-
0000
Y
Cleared after power down
1
10bit
Saving after stoppoing
0
Clear saving after stopping
command
1
Clear saving at end of
stopping
2
100bit
Reserved
1000bit
Reserved
1 bit: Saving state of potentiometer after power down
.
0: Saving after power down.
1: Clearing saving after power down.
10 bit: Keeping potentiometer set after stopping.
0:
Keeping after stopping
1: To clear saving after stop command.
2: To cear saving at end of stopping.
A51
Temperature adjustment of
motor
0.0~200.0
%
100.0
N
Being used to revise displaying of A54 motor temperature.
A52
Over-heat temperature of
0.0~300.0
℃
120.0
N