Powtran PI9000-S Series - Page 36

Chapter5.Function parameter
32
To run, firstly close DIn terminal, the motor run signal is generated by the ascendant
edge of DIx, the motor direction signal is generated by DIy status
To stop, you must disconnect DIn terminal signals Of which, DIx, DIy and DIn are
the multi-function input terminals of DI1 to DI10, DIx is for active pulse, DIy and DIn
are for active level.
Three-wire control mode 2
Command
FWD
REV
K
0
1
DIx
DIy
COM
SB2
DIn
Forward
Three-wire
operation
Reverse
Digital common
SB1
K
Of which:
SB1: Stop button SB2: Run button
F1.12
Minimum input value for
AIC1
0.00V to F1.14
0.00V
☆
F1.13
Corresponding setting for
F1.12
-100.00% to +100.0%
0.0%
☆
F1.14
Maximum input value
for AIC1
F1.12
～+100%
10.00V
☆
F1.15
Corresponding setting for
F1.14
-100.00% to +100.0%
100.0%
☆
F1.16
Minimum input value for
AIC2
0.00V to F1.14
0.00V
☆
F1.17
Corresponding setting for
F1.16
-100.00% to +100.0%
0.0%
☆
F1.18
Maximum input for
AIC2
F1.12
～+100%
10.00V
☆
F1.19
Corresponding setting for
F1.18
-100.00% to +100.0%
100.0%
☆
F1.35
DI terminal valid mode
selection 1
Single
digit
DI1terminal
activestatus setting
00000
★
High level active
0
Low level active
1
Tens
digit
DI2 terminal active
status setting (0 to 1,
sames as single digit)
Hund
reds
digit
DI3 terminal active
status setting (
0 to 1,
sames as single digit
)
Thou
sands
DI4 terminal active
status setting (
0 to 1,