Powtran PI9000-S Series - F2 Group - Output Terminals Group

Chapter5.Function parameter
33
digit
sames as single digit
)
Ten
thous
ands
digit
DI5 terminal active
status setting (
0 to 1,
sames as single digit
)
F1.37
DI1 delay time
0.0s to 3600.0s
0 . 0s
★
F1.38
DI2 delay time
0.0s to 3600.0s
0 . 0s
★
F1.39
DI3 delay time
0.0s to 3600.0s
0 . 0s
★
F1.40
Define the input terminal
repeat
0:unrepeatable
1:repeatable
0
★
5-1-4.F2 Group - Output terminals group
Code
Parameter name
Setting range
Factory
range
Chan
ge
Limit
F2.00
SPB terminal
output mode
selection
High-speed pulse output
0
0
☆
Switching quantity output
1
SPB terminal is a programmable complex terminals, it can be used as an output
terminal of high-speed pulse, also an switching output terminal of collector open circuit.
As a high-speed pulse output, the highest frequency of output pulse is 100kHz,
please see the instructions of F2.06 for high-speed pulse output function.
F2.01
Switching quantity
output function
selection (collector
Open circuit output
terminals)
0 to 40
0
☆
F2.02
Relay 1 output
function selection
(TA1.TB1.TC1)
0 to 40
2
☆
F2.03
Reserved
F2.04
SPA output function
selection (collector
Open circuit output
terminals)
0 to 40
1
☆
F2.05
Relay 2 output
function selection
(TA2.TB2.TC2)
0 to 40
1
☆
The above five function codes are used to select five digital output functions.
Multifunction output terminal function is described as follows:
Set
value
Function
Description