Powtran PI9000-S Series - Page 39

Chapter5.Function parameter
35
(shutdown without
output)
Outputs OFF signal when the inverter is in the
state of stop
19
Undervoltage status
output
Outputs ON signal when the inverter is in
the undervoltage condition
20
Communication
setting
Please refer to communication protocol.
21
Reserved
22
Reserved
23
Zero speed running 2
(shutdown with output)
Outputs ON signal when the inverter
output frequency is 0. Outputs ON signal too
when the inverter is in the state of stop
24
Accumulated power-
on time arrival
Outputs ON signal when the inverter's
accumulated power-on time(F6.08) exceeds the
set time by F7.20.
25
Frequency level
detection FDT2 output
Please refer to the instructions of function
code F7.26, F7.27
26
Frequency 1 reaches
output value
Please refer to the instructions of function
code F7.28, F7.29
27
Frequency 2 reaches
output value
Please refer to the instructions of function
code F7.30, F7.31
28
Current 1 reaches
output value
Please refer to the instructions of function
code F7.36., F7.37
29
Current 2 reaches
output value
Please refer to the instructions of function
code F7.38, F7.39
30
Timer reaches output
value
Outputs ON signal when timer(F7.42)is
active and after the inverter's current running
time reaches the set time.
31
AI1 input exceed limit
Outputs ON signal when the analog input
AI1 value is greater than F7.51 (AI1 input
protection upper limit) or less than F7.50 (AI1
input protection limit)
32
Load droping
Outputs ON signal when the inverter is in
the load drop status.
33
Reverse running
Outputs ON signal when the inverter is in
the reverse running status.
34
Zero current status
Please refer to the instructions of function
code F7.32, F7.33
35
Module temperature
arrival
Outputs ON signal when the inverter
module radiator temperature(F6.06)reaches the
set temperature(F7.40).
36
Software current
overrun
Please refer to the instructions of function
code F7.34, F7.35
37
Lower limit frequency
arrival(stop with output)
Outputs ON signal when the operating
frequency reaches the lower limit frequency
Outputs ON signal too when the inverter is in
the sate of stop
38
Alarm output
When the inverter occurs failure and
continues to run, the inverter alarms output.