Powtran PI9000-S Series - Page 62

Chapter5.Function parameter
58
abnormal
22
Inverter hardware
abnormal
23
Motor short to ground
26
Running time arrival
27
Custom fault 1
28
Custom fault 2
29
Power-on time arrival
30
Off load
31
PID feedback loss when
running
40
Fast current limiting
timeout
41
Switch motor when
running
42
Reserved
43
Motor overspeed
45
Motor overtemperature
51
Initial position error
y1.03
Frequency of the
third fault
Frequency of the last fault
●
y1.04
Current of the
third fault
Current of the last fault
●
y1.05
Bus voltage of the
third fault
Bus voltage of the last fault
●
y1.06
Input terminal
status of the third
fault
Input terminal status of the last fault, the
order is:
BIT9 BIT8 BIT7 BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
DI1 DI2 DI3 DI4 DI5 DI6 DI7 DI8 DI9 DI0
When the input terminal is ON, the
corresponding binary bits is 1, OFF is 0, all
DI status is converted to the decimal number
for display.
●
y1.07
Output terminal
status of the third
fault
Output terminal status of the last fault, the
order is:
When the output terminal is ON, the
corresponding binary bits is 1, OFF is 0, all
DI status is converted to the decimal number
●
BIT4
BIT3
BIT2
BIT1
BIT0
SPB
REL1
Reserve
SPA
REL2