Powtran PI9000-S Series - Page 63

Chapter5.Function parameter
59
for display.
y1.08
Reserved
y1.09
Power-on time of
the third fault
Current power-on time of the last fault
●
y1.10
Running time of
the third fault
Current running time of the last fault
●
y1.11 to
y1.12
Reserved
y1.13
Frequency of the
second fault
Frequency of the last fault
●
y1.14
Current of the
second fault
Current of the last fault
●
y1.15
Bus voltage of the
second fault
Bus voltage of the last fault
●
y1.16
Input terminal
status of the
second fault
Input terminal status of the last fault, the
order is:
BIT9 BIT8 BIT7 BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
DI1 DI2 DI3 DI4 DI5 DI6 DI7 DI8 DI9 DI0
When the input terminal is ON, the
corresponding binary bits is 1, OFF is 0, all
DI status is converted to the decimal number
for display.
●
y1.17
Output terminal
status of the
second fault
Output terminal status of the last fault, the
order is:
When the output terminal is ON, the
corresponding binary bits is 1, OFF is 0, all
DI status is converted to the decimal number
for display.
●
y1.18
Reserved
y1.19
Power-on time of
the second fault
Current power-on time of the last fault
●
y1.20
Running time of
the second fault
Current running time of the last fault
●
y1.21 to
y1.22
Reserved
y1.23
Frequency of the
first fault
Frequency of the last fault
●
y1.24
Current of the
first fault
Current of the last fault
●
y1.25
Bus voltage of
Bus voltage of the last fault
●
BIT4
BIT3
BIT2
BIT1
BIT0
SPB
REL1
Reserve
SPA
REL2