13/18
LED INDICATION
On
DMX signal OK
Off
No DMX signal
Green
Flash
DMX signal error
Yellow On
Setting the panel
Blue On Power
Red
Slave mode or Running self test mode
Red/Green
Green
Master mode
MAINTENANCE
To prolong the life of the projector, some maintenance work has to be done to ensure the LED opt al system in good
condition. If the projector does not function, check the fuses on the power socket of the proje tor, they should only be
replaced by fuses of the same specification. Should these be damaged, call a qualified techn cian efore replacement.
The projector has thermal protection device that will switch off the projector in case of overheating.Should either of these
operate, check that the fans are not blocked, and if they are dirty, clean them before s itching on the projector again.
Check that the fans are operational, if not, call a qualified technician.
Any maintenance work should only be carried out by qualified technician .
KEEPING THE PROJECTOR CLEAN
To ensure the reliability of the projector, it should be kept cle n It ecommended that the fans should be cleaned
every 15 days. LED lens should also be regularly cleaned o ma ntain an optimum light output.
Cleaning frequency depends on the environment in wh ch the fixture operates: damp, smoke or particularly dirty
surroundings can cause greater accumulation of dirt o he nit’s optics. A soft cloth and typical glass cleaning products
should be used for cleaning. It is recommended to cl an the external optics at least once every 20 days.
Do not use any organic solvent, e.g. alcoh to clean housing of the apparatus.
TROUBLESHOOTING
PROBLEM ACTION
The projector doesn’t switch on ¾ Check the fuse on the power socket.
The lamp comes on but the projector
doesn’t r spond to the controller
¾ Make sure that the projector is correctly configurated.
¾ Replace or repair the DMX cable.
The beam appears dim ¾ Check that the optics is clean.
To Next Page
Loading...
