16/22
INDICATION OF LED DIGITAL TUBE
On DMX signal OK
Decimal point of the first digital tube
Off No DMX signal
On Master / slave signal is OK
Decimal point of the third digital tube
Off No master / slave signal
On When setting master mode
Decimal point of the fourth digital tube
Off When setting slave mode
Parameters that LED digital tubes display Flash Parameters not saved, press “ENTER” to save them
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or deformed in any way it
must be replaced. If the light from the lamp appears dim this would normally indicate that it is reaching the end of its life and it should
be changed at once, aged lamps run to the extremity of their life might explode. If the projector does not function, check the fuses on
the power socket of the projector, they should only be replaced by fuses of the same specification. Should these be damaged call a
qualified technician before replacement. The projector has thermal protection device that will switch off the projector in case of
overheating, should either of these operate, check that the fans are not blocked, and if they are dirty clean them before switching on the
projector again. Check that the fans are operational, if not call a qualified technician.
Any maintenance work should only be carried out by qualified technicians.
LUBRICATION
To ensure the continuous rotation of the rotating gobos and linear motion of the lens for focusing, it is recommended that the bearings
for the rotating gobos and the 2 shafts for the focusing lens holder be lubricated periodically, preferably every two months. Use only
high quality, high-temperature resistant grease instead of any type of oil. When lubricating the bearings, a syringe with a fine needle is
the easiest way to introduce the grease to the bearings around each gobo.
KEEPING THE PROJECTOR CLEAN
To ensure the reliability of the projector it should be kept clean. It is recommended that the fans should be cleaned every 15 days. The
lens and dichroic colour filters should also be regularly cleaned to maintain an optimum light output.
Do NOT use any type of
solvent on dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoke or particularly dirty surroundings can
cause greater accumulation of dirt on the unit’s optics. A soft cloth and typical glass cleaning products should be used in cleaning. It is
recommended to clean the external optics at least once every 20 days and clean the internal optics at least once every 30 / 60 days.
Do not use any organic solvent, e.g. alcohol, to clean the reflector mirror, dichroic colour filters or housing of the apparatus.
TROUBLESHOOTING
PROBLEM ACTION
To Next Page
Loading...
