7 Operation
7.2 Accessories Installation (only for P7500i)
Remove accessories
Remove the attachment, remove the generator and attachment box from
the packing box, and count the number of attachment according to the
following table.
Wheel kit installation
Tool requirements: 12 mm wrench, 10 mm wrench, crosshead screwdriver
used for battery wiring and clamp.
WARNING
It is strictly forbidden to run the generator when the wheel kit is not
installed. The wheel kit provides air flow space between the ground and the
inlet of generator.
WARNING
If the wheel kit is not installed, dust and debris may be sucked into the duct
of generator, which will cause damage to the generator. Be sure to run the
generator after the wheel kit is installed.
To Next Page
Loading...
