7 Operation
34
Using the funnel (provided) fill with 0.4 L of SAE 10W-30 or 10W-40 (provided)
(see figure 3). See figure 4 for proper oil level.
(Figure 4: left image for P3000i-P3500i-P3500Io, right image for P7500i)
Replace oil filler cap and secure side panel with screws.
Recommended engine oil:
A. YAMALUBE4(10W-40) SAE10W-30 or 10W-40
B. SAE #30
C. SAE#20
D. SAE#10W
Recommended engine oil grade: API Service SE type or higher
Engine oil quantity: see Technical data
Adding Fuel
The fuel tank capacity: see Technical data
DO NOT overfill the tank, otherwise it may overflow when the fuel warms up and
expands.
NOTE: For safety reasons, once fuel has been added to this unit it cannot be
returned to the place of purchase.
1. Use clean, fresh, regular unleaded fuel with a minimum octane rating of 87.
2. DO NOT mix oil with fuel.
3. Clean area around the fuel cap.
4. Remove the fuel cap.
5. Be sure that the fuel strainer is in place.
6. Slowly add fuel to the tank.
7. Do not exceed the red marker position of the fuel filter.
8. Screw on the fuel cap and wipe away and spilled fuel.
NOTE: Use only unleaded gasoline. The use of leaded gasoline will cause severe
damage to internal engine parts.
After filling with fuel, make sure the fuel tank cap is tightened securely.
To Next Page
Loading...
