7 Operation
36
17.12.2 P7500i
1. According to the required voltage requirements, select the gear of
voltage change-over switch.
2. Turn the switch to “On” position.
3. Press and release the start switch button. The start switch will start the motor
for 5 seconds. When the engine starts successfully, the starter will stop
automatically. If the engine does not start successfully, wait at least 10
seconds before starting again.
NOTE: Is it also possible to start the engine with the recoil starter:
1. Turn the lock 90° anticlockwise and open right maintenance door. Pull
slowly on the recoil starter until it is engaged and then pull it briskly. Turn the
lock 90° clockwise and close right maintenance door.
7.13 Stopping the Engine
Before stopping the engine turn off and disconnect any electronic devices attached
to the generator.
Turn the Throttle switch “O”.
To Next Page
Loading...
