9551021_1 1
AgLeader 800/1200 GPS Setup Guide
This guide is intended for use when connecting the 20|20 to an Agleader Incommand 1200 GPS
display to acquire GPS data. It can be utilized with the following configurations:
• InCommand 800/1200 with GPS 600/6500/7500
• InCommand 800/1200 with GPS 600/6500/7500 with Port B RTK signal.
The basic GPS requirements for the 20|20 monitor are:
• NMEA Strings : 5hz
• Baud Rate : 19200 or 38400
• GGA : Required for time, position, and fix type data.
• RMC : Required for time, date, position, course and speed data.
• VTG : Required for course and speed information relative to the ground.
The status of GPS communications on the AgLeader display is indicated by the Satellite icon in
the top right corner of the screen.
• Green — Accurate GPS communications.
• Yellow — GPS communications below 100%.
• Grey — No GPS communications.
To Next Page
