The Precision Toy Train Tools USA (PTTTUSA) STX-360 Adjustable Rivet and Wheel
Press system is a unique, accurate, heavy-duty tool system developed for the repair of
toy trains. Precise alignment of tooling components is made quickly and simply with the
PTTTUSA exclusive adjustable base plate design and accompanying alignment tool.
The PTTTUSA press and tooling system will enable you to perform factory-like results in
your home workshop or your service station.
In addition to the best press available, our tooling system includes high quality rivet
clinchers, punches, rivet anvils, axle insertion tools, wheel cups and specialty tools.
This booklet has been prepared to provide you with an overview of how to set up the
press and use its basic features. Greater detail can be found in our user manual.
SETUP & GENERAL USE INSTRUCTIONS
Please read this information completely before attempting to setup and use your
STX press!
UNPACKING THE PRESS
Your STX press system has been partially disassembled for ease in shipping. Carefully
unpack and identify all of the components using the reference at Figure 1.
1. Press assembly with base plate
2. Lever arm and pinion gear assembly with arm locking knob
3. Retaining collar for lever arm and appropriate hex key
4. Hex Key for Base Plate Socket Head Cap Screws
5. STX-360-37 Tapered Setup Tool with Protective Cap
6. STX-360-38 Solid Plate Plug for flat working surface
7. STX-360-34 Threaded Anvil holder with Two Lock Nuts
8. Thumb Screws Installed in Base Plate and Ram
9. 2 Set Screws with Hex Key
Not Shown: Two Delrin slide strips installed inside press head as shipped.
Setup Instruction Booklet.
**If any of the above components are damaged or missing, please contact us
immediately. In the event of damage, inspect the shipping carton for abuse and notify
the carrier. Keep all shipping material.
To Next Page
Loading...