16
To Change Data: To change the value within the
command type the command code followed by the
new value and ENTER (Return).
Example 1: To change Setpoint Temperature to
25.0°C type:
T25.0 <CR>
Example 2: To change Setpoint Temperature to -
.8°C type:
T-.8<CR>
(A) Actual Temperature: The actual
temperature within the incubator.
(T) Setpoint Temperature: The temperature at
which the user has selected the incubator
to operate.
(R) Baud Rate: The rate at which data is
transmitted between the incubator and your
computer
0 = 300 Baud
1 = 600 Baud
2 = 1200 Baud
3 = 2400 Baud
4 = 4800 Baud
5 = 9600 Baud
(S) Status Update Time Interval: The time
between data messages sent from the
incubator to your computer
0 = 0 Minutes, No report
1 = 0.1 Minutes (6 seconds)
2 = 0.5 Minutes (30 seconds)
3 = 1.0 Minutes
4 = 2.0 Minutes
5 = 5.0 Minutes
6 = 10.0 Minutes
7 = 30.0 Minutes
8 = 60.0 Minutes
(V) EPROM Version Number: The incubator
software version level.
(D) Status Display Type: Selection of format
that data is sent to your computer
0 = Used for a raw, one-line status output
suitable for importing into a spreadsheet
1 = Used for a multi-line format with English
headings
2 = Used for the format as “1” but preceded
by a clear screen command used by
terminals or computers running terminal
software.
(O) Display the Alarm Status: The alarm
has thee (3) possible values:
0 = Normal, no alarms
1 = Low alarm
2 = High alarm
To Next Page
Loading...
Need help?
General