Rev 8/2014
PrecisionTemp, Inc • 11 Sunnybrook Drive • Cincinnati, Ohio, 45237 • 1-800-934-9690 •
fax 513-641-0733 44
SB-6 Direct Spark Ignition (DSI) Board Change
Model: PT-200FT, PT-200RC & PT-56
Software version: All
Tools Required: screw driver
Process:
1. Turn booster power switch off and remove front cover.
2. Open the electrical drawer and pull all the way out from its saddle.
3. Remove the DSI board.
4. Install the new DSI board and re-attach the wire harnesses. Be sure to route
the yellow or black ignition wire separate from the other control harnesses. (If
a new harness is supplied, use it and discard the old harness.)
5. Replace front cover and turn booster power switch on.
6. Ensure proper operation of the booster heater by running several racks
through the dish machine and ensuring that proper rinse water temperature is
reached.
Kit Parts List:
P/N 3158 Direct Spark Ignition (DSI) board
(#3166 bracket if required)
Reference Illustrations:
200-3158 & 200-3166
To Next Page
Loading...