Rev 8/2014
PrecisionTemp, Inc • 11 Sunnybrook Drive • Cincinnati, Ohio, 45237 • 1-800-934-9690 •
fax 513-641-0733 56
SB-16 T-Out/ T-In Thermistor Change Procedure
Model: PT-200FT, PT-200RC & PT-56
Software version: All
Tools Required: Scissors (or other cutting tool)
Process:
1. Disconnect power to the booster.
2. Remove the wire ties, metal tape, and old thermistor. Clean off the old heat
sink and be sure copper is wiped clean.
3. Place a pea size amount of heat sink compound on the pipe where the
thermistor will be located.
4. Place the thermistor into the heat sink with the wire leads pointing down along
the tube.
5. Wrap metal tape around the tube and thermistor.
6. Attach the wire tie. Wrap the wire tie about 1/2” away from the thermistor
head to hold the thermistor against the tube. CAUTION: 1) Do not place the
tie wrap over the thermistor tip as this may damage the thermistor, do not
over-tighten the wire tie.
7. Connect the thermistor to the wiring harness.
8. Replace front cover of booster heater and turn power switch back on.
9. Perform test of the unit by running several racks through the dish machine to
ensure that proper rinse temperature is reached.
Kit Parts List:
1436 T-in Thermistor Assembly Kit
1437 T-out Thermistor Assembly Kit
Reference Illustrations:
200-13 Thermistor Harness
To Next Page
Loading...