PRECITEC ProCutter 2.0 - Page 3

Training packages – Part 2
Settings EG unit (practice)
− Device operation
− Connecting the IO/Bus
− Calibration, homing, etc.
− Error messages
Handling optics (theory)
− Optic replacement
− Optic check
− Optic cleaning
Cleaning optics (practice)
− Handling collimation
− Protection of the fibre socket
− Pre-cleaning of the optics
− Cleaning inside a Flowbox
− Maintenance for OEM (service)
− Recommended spare parts
ProCutter 2.0 settings (practice)
− Centring of the laser beam (X-Y)
− Set up the focus position
− Set up the working distance
Troubleshooting (practice)
− Cutting errors
− Error messages EG
− Error messages Sensor