Precor AMT 885 - Page 14

7
Remove the AMT from the pallet
After the side arm supports are secured, move the AMT off of its shipping pallet to the location where it will be used.
CAUTION
DO NOT move the AMT off its shipping pallet without assistance. DO NOT apply any weight to the side arms of the AMT until the side arm supports
have been installed. To avoid unnecessary movement of the foot plates, DO NOT position the handlebars until instructed to do so.
To move the AMT from the pallet:
1. Remove and discard the two fasteners securing the front frame tube of the AMT
to the shipping pallet (see Figure 8).
Figure 8
2. Lift the back end of the center support and roll the AMT forward onto the floor
while your assistant stabilizes its front end and guides it off the shipping pallet.
3. Move the AMT to its intended location.
4. Insert the end caps into the front frame tube, and if needed, use a rubber
mallet to tap them into place.