To continue the wiring:
1. Pass the ends of all cables through the opening in the top of the cable channel
and secure them in the cable clips.
2. Route the cables through the cable clips next to the front flywheel, through the
topmost cable clip on the main frame, and up to the center support (see
Figure 13).
Figure 13
3. Remove the tie from the base data cable. Group that cable with the others and
thread them upward through the center support and out through the center
opening in the console mount, making sure that the heart rate sensor cable
extends out of the opening as well.
Important Store excess cable inside the center support. DO NOT allow cables to
hang loosely inside the body of the AMT.
To complete the console installation, refer to the Installation Guide included in your console box.
To Next Page
Loading...
