C954, C956 Treadmill
Page 1-76 Page 76
drifting stops. The adjustments should only be done in 1/4 turn increments. NOTE: ONLY use the
right side take up roller mounting bolt to adjust tracking.
21. Increase the speed to 3 mph for a minute, then 6 mph, 9 mph and finally 12 mph, making any small
adjustments as needed.
22. Set the treadmill speed to 3 mph and walk on the treadmill for a couple of minutes. Verify that the
belt has not moved. Adjust the right side take up roller mounting bolt if needed to make final
adjustments.
23. If applicable, replace the finger guard.
24. Replace both running deck trim strips and the end caps and motor cover.
To Next Page
Loading...
