page 17
COMMERCIAL PRODUCTS DIVISION
the base frame holes. Insert four bolts (G) and washers (H) on both sides.
Thread the bolts through the unit. See Diagram 11. You may need to adjust
and gently move the stabilizers up and down to get the mounting holes on
both sides of the base frame properly aligned.
g. Tighten the bolts so that the unit is stable, but leave room for final adjustments.
Do not securely tighten the bolts until the unit has been fully assembled.
18. Tighten all mounting screws using a 9/16" wrench. Diagram 12.
Tighten the bolts
on the base
frame first.
Diagram 12
Tighten the
mounting bolts.
2
3
1
Upright support
bracket
Left frame stabilizer
Base frame
Upright support
To Next Page
Loading...
