page 18
COMMERCIAL PRODUCTS DIVISION
Diagram 13
Secure the
handlebars.
Protrusions
Handlebar
bracket
Tighten bolts securely.
a. Ask for assistance to remove the supportive wedge from beneath the base
assembly and to turn the unit onto its side.
b. With the unit on its side, start at the base with the eight bolts that attach the
frame stabilizers to the base frame. Tightening these bolts first helps pull
the rest of the parts into alignment. Proceed with securely tightening the
bolts attached to the upright support bracket and the bolts that secure the
upright support to the base frame.
19. Attach the left and right handlebars. Diagram 13. Perform the following
steps on one side of the unit and then, repeat the steps on the opposite side.
a. Remove the three bolts (E) and washers (F) from the Hardware kit. Place
the washers on the bolts.
b. Attach one handlebar at a time. Note that the handlebars’ mounting holes
Diagram 14
Secure the
handlebars to the
pivot arm.
Shoulder bolt (C)
Handlebar
5/16-inch hex key
Pivot arm
To Next Page
Loading...
