28 Assembling and Maintaining the RBK 615 Recumbent Exercise Bike
To attach the bottle holder:
1. Move the seat as far back as it can go.
2. Position the bottle holder so that the two tabs on its
underside are aligned with the bottle holder bracket.
3. Slide the bottle holder forward so that its tabs fit around
the bracket and the screw holes on the bottle holder and
the bracket line up, as shown in the following figure.
Figure 11: Bottle holder positioning
4. Attach an M5 x 16 mm buttonhead screw and a 5 mm flat
washer to secure the bottle holder in place, as shown in
the following figure. Tighten the screw completely using a
3 mm hex wrench.
Figure 12: Securing the bottle holder in place
To Next Page
Loading...
